Verify that the device bay is configured for a half-height
compute module. For more information, see the setup and installation guide for the
frame on the
Hewlett Packard Enterprise website.
Remove the compute module end cap.
Prepare the
compute module for
installation by opening the
compute module
handle.
Install the
compute module.
Slide the
compute module until it is fully inserted in the enclosure slot. Rotate the handle until it latches.
Review the
compute module front panel LEDs to determine the
compute module status. For more information on the
compute module LEDs, see "Component identification."
To remove the component, reverse the installation procedure.
CAUTION:
Before removing the compute module, be sure to verify that the compute module is in standby mode by observing that the system power LED is amber. Also, verify that the UID LED is not flashing blue.
