Base configurations

The HPE Edgeline EL4000 System comes in the following configurations:

• HPE Edgeline EL4000 4x10GbE 2xQSFP+ PassThru System

  Supports 1 to 4 full-height, half-length PCIe cards. The core network is pass-through. A separate 1G RJ-45 network port is provided for access to the iLO management network.

• HPE Edgeline EL4000 10GbE 2xSFP+ Switch System

  Supports 1 to 4 full-height, half-length PCIe cards. The core network is Layer 2 switched. A separate 1G RJ-45 network port is provided for access to the iLO management network.

• HPE Edgeline EL4000 10GbE 2xSFP+ Switch PXIe System

  Supports 1 to 4 PXIe modules. The core network is Layer 2 switched. A separate 1G RJ-45 network port is provided for access to the iLO management network.

  Supports 1 to 1 PXIe module configuration. This configuration requires minimum CPLD version of Rev 10 (0x0A). For more information, see DIP switch positions for PXIe mapping.

  Supports 1 to 2 PXIe module configuration. This configuration requires minimum CPLD version of Rev 10 (0x0A). For more information, see DIP switch positions for PXIe mapping.

  IMPORTANT: Power cycle the chassis after the CPLD is updated.

  IMPORTANT:

  Disable Spread Spectrum on the HPE ProLiant m510 and m710x server cartridges before changing the chassis configuration to enable 1 to 2 or 1 to 1 PXIe mapping.

For identification of system components, see the following:

• PCIe configuration
• PXIe configuration