Installing an internal USB device

Procedure

Power down the server.
Remove all power:
1. Disconnect each power cord from the power source.
2. Disconnect each power cord from the server.
Disconnect all peripheral cables from the server.
Do one of the following:
- If the server is in tower mode: Position the tower server for hardware configuration.
- If the server is in rack mode: Remove the server from the rack.
Remove the front bezel.
Remove the access panel.
If installed, remove the air baffle.
Locate the internal USB connector.
Plug in the USB device into the internal USB port.
If removed, install the air baffle.
Install the access panel.
Install the front bezel.
Do one of the following:
- If the server is in tower mode: Position the tower server for operation.
- If the server is in rack mode: Install the server on the tray.
Connect all peripheral cables to the server.
Connect the power cords:
1. Connect each power cord to the server.
2. Connect each power cord to the power source.
Power up the server.

The installation is complete.