Quick Start: Add HPE Synergy Image Streamer devices to an existing HPE Synergy configuration

• Image Streamer requires two service ports. Use the ports on the HPE Virtual Connect Module for Image Streamer cabling.

• Ensure that the Image Streamer appliances within the frame are connected to the compatible and supported frame link modules.

  NOTE:

  Image Streamer appliances can interoperate with only HPE Synergy two-port Frame Link Module in the frame.

HPE OneView Network or Infrastructure administrator

Service ports are the Q{x}.1 and Q{x}.2 uplink ports on the HPE Virtual Connect SE 40Gb F8 Module for HPE Synergy or the X1 and X2 uplink ports on the HPE Virtual Connect SE 100Gb F32 Module for HPE Synergy that are connected to the Image Streamer appliance through the MGMT ports of the Frame Link modules. For HPE VC SE 100Gb F32 Module, X1 and X2 uplink ports are the dedicated SFP+ ports.

1. If necessary, reconfigure the existing Virtual Connect uplinks to use five or fewer QSFP+ ports.

Data center technician

1. Install and cable the Image Streamer hardware

   For requirements and procedures to set up a single frame or up to five frames cabled together in a multiframe configuration, see the HPE Synergy Configuration and Compatibility Guide at http://www.hpe.com/info/synergy-docs.

2. Check power and health

   Confirm that the appliance power and health LEDs are green, and then inform the HPE OneView Infrastructure administrator that the Image Streamer devices are ready for configuration.

HPE OneView Infrastructure administrator

1. Ensure that the appliances have been discovered and validated.

2. You are now ready to configure resources in HPE OneView to support the operation of Image Streamer appliances.