The server lift may require assembly after removing it from the shipping container.
Position the lift horizontally on the floor so all four wheels rest on the floor. Refer to the figure included below.
CAUTION:
Personal or equipment injury.
Two people are required to perform this procedure. Failure to assemble the server lift with two people could cause personal injury or equipment damage.
Slide each leg into a base socket until the leg lock pin snaps into the leg.
Stand the lift back up vertically.
Slide each fork onto the fork support tubes and secure each side with two lock pins.
Position the server platform onto the forks. The top-back of the platform fits behind the lower fork support tube. No tools or hardware are needed.
Note: An earlier lift model included a three-sided server platform that slid onto the forks and a cable and carabiner that held the platform in place.
Remove and reverse the winch handle so the handle grip faces the operator. Verify the winch handle pin locks the handle in place.
