Prerequisites for bringing an HPE BladeSystem c7000 Enclosure into HPE OneView
Item | Requirement |
|---|---|
Enclosure model | The enclosure must be a supported model listed in the HPE OneView Support Matrix. The enclosure is powered on. |
Server hardware | The server hardware seated in an enclosure must meet the prerequisites listed in Prerequisites for bringing server hardware into an appliance. |
Firmware | The enclosure firmware must be at least the minimum supported firmware version listed in the HPE OneView Support Matrix. |
Onboard Administrator | The primary and standby HPE BladeSystem Onboard Administrator must be configured with a host name or IP address and must be reachable by HPE OneView. As part of bringing an Onboard Administrator under management, a local user account is added, so the Onboard Administrator must be configured to allow for local user accounts. If the enclosure has two Onboard Administrator, both must be at the same firmware version. |
IP addresses | IPv4 or IPv6 configuration is required. |
iLO IP address | Server hardware iLO must be configured with IP addresses, automatically with DHCP addresses or manually with Enclosure Bay IP Addressing (EBIPA)-specified addresses. HPE OneView must be able to connect to the server hardware iLO. |
Interconnects | Interconnects must be configured with: IP addresses, automatically with DHCP addresses, or manually with EBIPA-specified addresses.
|
Open ports | The following ports must be opened between HPE OneView and the enclosure:
|