Removing the Top Plastic Guard From the Fuse Panel

Do not remove the top plastic guard unless you are instructed to do so as part of an installation or replacement procedure.

Procedure
Remove the top plastic guard from the cable management tray for the fuse panel:
  1. Using a T-20 Torx driver, unscrew the two M4 screws. The screws are located at each end of the fuse panel on the fuse panel support brackets, directly above the cable management tray (Figure 2: Fuse Panel Top Plastic Guard and Mounting Screws).
  2. Lift the panel up and out of the cabinet and set it aside.
    WARNING:

    Power is still being supplied to the fuse panel. Use caution when working around the exposed terminal blocks and cable lugs.

    Figure 2: Fuse Panel Top Plastic Guard and Mounting Screws