Installing the premium four-drive kit for two SAS/SATA and two NVMe drives

Procedure
  1. Power down the compute module.
  2. Remove the compute module from the frame.
  3. Place the compute module on a flat, level work surface.
  4. Remove the access panel.
  5. Install the front drive cage.
    NOTE:

    If a drive cage is present, disconnect and remove the drive cage.

    Installing the front drive cage. Make sure you press down on both sides of the front drive cage.
  6. Install the drives.
  7. Connect the SLIM/SAS cable to the Port 3i connector and to the drive assembly.
    Key points of the SLIM/SAS cable highlighted
  8. Install the access panel.
  9. Install the compute module.
  10. Power on the compute module.