Installing the front PCIe accelerator enablement kit

Procedure
  1. Power down the compute module.
  2. Remove the compute module from the frame.
  3. Place the compute module on a flat, level work surface.
  4. Remove the access panel.
  5. Insert the peg of the direct connect cable into the slot on the side of the front PCIe accelerator enablement kit. Then, rotate the cable upward until it clicks into the post. Finally, connect the cable to the drive assembly.
    Arrow 1: Insert the peg of the direct connect cable into the slot on the side of the front PCIe accelerator enablement kit. Arrow 2: Rotate the cable upward until it clicks into the post. Arrow 3: Connect the cable to the front PCIe accelerator enablement kit.
  6. Install the front drive cage.
    NOTE:

    If a drive cage is present, disconnect and remove the drive cage.

    Installing the front drive cage. Make sure you press down on both sides of the front drive cage.
  7. Install the access panel.
  8. Install the compute module.
  9. Power on the compute module.