Installing the standard two-drive kit

Procedure
  1. Power down the compute module.
  2. Remove the compute module from the frame.
  3. Place the compute module on a flat, level work surface.
  4. Remove the access panel.
  5. Install the front drive cage.
    NOTE:

    • If a drive cage is present, disconnect and remove the drive cage.

    • No cabling is required for the two-drive kit.

    Installing the front drive cage. Make sure you press down on both sides of the front drive cage.
  6. Install the drives.
  7. Install the access panel.
  8. Install the compute module.
  9. Power on the compute module.